Whether you don't have the equipment, personnel or the time available to get the job done. A.A. Jansson can be your primary or backup source for your inspection needs. The laboratory is staffed with inspectors and equipment to get the job done accurately and on time. A.A. Jansson is accredited to ISO17025:2005 and ANSI/NCSL Z540.
If you don't have the equipment to perform the job let A.A. Jansson be your source for surface roughness, profile and Waviness measurements. A.A. Jansson utilizes the Mitutoyo SJ-400 series Roughness tester. This tester allows for both skidless and non-skidless operation. The unit supports ANSI, DIN and ISO Standards. The SJ-400 series comparator mounted on a column allows for High accuracy measurements on flat and cylindrical surfaces. Both Straightness and Waviness are easily measured by switching to skidless measurement mode. Parameters supported are Ra, Ry, Rz, Rq, Pc, R3z, mr, Rt, Rp, Rv, Sm, S, δc, Rk, Rpk, Rvk, Mr1, Mr2, A1, A2, Lo, Ppi, R, AR, Rx, ∆a, ∆q, Ku, HSC, mrd, Sk, W, AW, Wte, Wx, Vo
Need part inspection. Our Contact and Non-contact inspection services will measure your parts accurately and on time. Our knowledgeable and experience staff, along with our vast selection of measuring equipment and software allow us to meet your most demanding measurement requirements.
Engineering determines how round a part needs to be. However it is metrology's job to verify if the specification has been met. The world is dependent on machines with rotating parts. We know that controlling roundness can improve performance. However the cost of a roundness machine can be expensive. If you don't have enough work to justify the cost there is no need to worry. A.A. Jansson is accredited for roundness inspection can save you the cost. Just another way A.A. Jansson helps add to your bottom line.Request Information